Winplus Yada Blind Spot Assist System Spécifications télécharger pdf (Page 5)

1. Frequency: 2.4GHz

2. Operating Voltage: DC 12V / 24V

3. Operating Temperature: -10~+50°C

4. Maximum Signal Range: 30 feet/10Metres

(without Interference or Obstruction)

5. Camera Water Resistance: IP67 rating

DASH MONITOR INSTALLATION

1. Stick the Suction Cup Mount on the windshield and adjust to your desired position.

2. Hook the Dash Monitor on to the windshield mount.

3. Remove the Yada Dash Monitor protective overlay.

4. Now power the monitor:

a. 12V/24V Power Adapter

Take the 12V/24V Power Adapter and plug adapter into the right side of the Yada Dash

Monitor. Plug the other end into 12V/24V power port in your car.

b. Hard wire

Take the Hard Wire Power Adapter and plug adapter into the right side of the Yada Dash

Monitor. Run cable to fuse box and connect to fused accessory power source. Refer to

your vehicle owner manual for location of available accessory fuses.

5. At this time, the Yada Dash Monitor is ready to be automatically powered on when the vehicle

engine starts.

Warning: Many vehicles provide constant power to the 12V outlet. If your outlet provides constant

power, please remember to unplug the monitor when not in use to avoid draining the vehicle

battery.

BACKUP CAMERA INSTALLATION

Note: Camera installation on diesel vehicles may require dierent wiring install. See Below. You can

3. PRODUCT SPECIFICATIONS

4. INSTALLATION GUIDE

1 2 3 4 5 6 7 8 9 10 ... 21 22

Pas de commentaire

Winplus Yada Blind Spot Assist System Spécifications Page 5