Winplus Yada Blind Spot Assist System Spécifications

8PAIRING The Yada Backup Camera (Camera 1) included with this Expandable System is already paired with the monitor. If you can not see the Camera imag

9a. Press “Menu”b. Go to “Pair Camera” and select “Camera 2”c. Press “Parking Aid line” to conrmd. The unit is now in pair mode - if the monitor

10WARNING: A failure to read and follow these warnings and instructions may result in a serious accident, including damaged property or a serious inj

11opposite than when viewed in the rear view and outside mirrors. Use the inside mirror or glance over your shoulder to properly judge distances to o

12• Do not submerge Camera in water, which can cause internal damage to the Camera.• If the temperature changes rapidly, such as when hot water is p

13CLEANING• If dirt, rain or snow attaches to the Camera, the monitor may not clearly display objects. If water droplets, snow or mud adhere to the

14due to normal wear and tear.5. Repair or replacement parts supplied by Winplus North America under this warranty are protected only for the unexpir

15 Winplus North America and/or its aliates do not guarantee or promise that the user of Backup Camera Expandable System will not be in an accident

16and workmanship for 12 months from the date of original purchase. Where permitted by law, Winplus liability shall be limited to that set forth in t

17CUSTOMER SERVICE/CONTACT For questions or issues regarding the product, please visit www.letsyada.com or contact Winplus in your area/region to spea

TABLE OF CONTENTS1. Introduction ...

18• Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected• Consult the dealer or an experienced ra

19IMPORTANT NOTE:IC Radiation Exposure Statements:This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment.

www.winplus.com www.letsyada.com© 2014 Winplus North America Inc. All Rights Reserved. Winplus, the logo design, and Yada are trademarks or registered

1Please read all of the installation instructions carefully before installing the product. Improper installation will void manufacturer’s warranty.

21. 5” Dash Monitor2. 1 Backup Camera3. 12V/24V Power Adapter for Monitor4. Hardwire Cable for Monitor5. Suction Cup Mount for Monitor6. Install

31. Frequency: 2.4GHz2. Operating Voltage: DC 12V / 24V3. Operating Temperature: -10~+50°C4. Maximum Signal Range: 30 feet/10Metres (without Inter

4also watch some common installation videos at www.letsyada.com for more information.Caution: This unit is designed to operate on a 12V/24V DC NEGATIV

510. Use the provided Zip ties to secure wires neatly within your car.11. Replace the light socket back into the reverse light housing.12. Replace

65. SETTINGS AND OPERATIONPOWER ON/OFF• The Dash Monitor will automatically turn ON when it is connected to a power source. • Hold the power button

7BRIGHTNESS AND CONTRAST You can adjust the contrast and brightness of the Monitor according to your desired level. Note: Contrast and Brightness sett